RF Signal Booster for Water Level Controllers
A strong, stable wireless link between your tanks and controller, across any number of floors or blocks
The Aquabrim Wireless Signal Booster is an RF signal booster that extends the range between Aquabrim tank sensors and controllers. In most homes, the wireless signal travels easily from the terrace tank to the controller near the motor. In tall buildings, thick reinforced concrete or large campuses, the signal can weaken before it reaches the controller. The booster solves this.
A weak signal means missed readings. The controller may not get the latest tank level, which can delay motor start, cause overflow or trigger false alerts. Installers often run into this in high-rise apartments in Mumbai and Gurgaon, in basements with deep underground sumps, and on campuses where tanks sit hundreds of metres from the pump room. An RF signal booster picks up the sensor’s signal and passes it on with full strength, so every reading reaches the controller reliably.
The booster works with all Aquabrim wireless sensors and controllers, including the water tank level sensor, non-contact water level sensor, Trigger, Macro and Matrix. You place it at a midpoint between the tank and the controller, and it starts relaying the signal automatically. No changes are needed to your existing setup.
Key Features
Technical Specifications
Everything you need to know about the Wireless Signal Booster at a glance.
FAQ
Frequently Asked Questions
An RF signal booster receives a weak radio signal and passes it on at full strength. Aquabrim’s booster does this for the wireless link between tank sensors and controllers.
Most homes don’t. You need one if your building is tall, has thick reinforced concrete, has a deep basement sump, or if the tanks are far from the controller on a large campus.
Signs include the controller showing old or missing tank levels, the motor starting late, or frequent signal alerts. Aquabrim’s team can check signal strength during installation.
No, this booster is built only for Aquabrim’s RF link between tank sensors and controllers. It doesn’t boost mobile network or Wi-Fi signals.
It works with the water tank level sensor, non-contact water level sensor, and the Trigger, Macro and Matrix controllers.
Place it roughly midway between the tank and the controller, on a floor or wall where it can receive the sensor’s signal clearly.
Yes, on very large campuses or very tall buildings, more than one booster can be used to cover the full distance. Aquabrim’s team will plan the right setup.
Yes, it’s plug-and-play: place it at the midpoint, power it on, and it starts relaying the signal automatically.
Weak Signal Between Tank and Controller?
Get a strong, stable wireless link across floors, blocks and campuses.